Wave Home Solutions WV-SCBT Dokumentacja

Przeglądaj online lub pobierz Dokumentacja dla Zdalne sterowanie Wave Home Solutions WV-SCBT. Wave Home Solutions WV-SCBT Specifications Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 15
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
READ CAREFULLY AND RETAIN FOR FUTURE REFERENCES
INSTALLER’S MANUAL
Sensor Control BT
WV-SCBT
Wave Home Solutions
2421 Long Beach Road
Oceanside, NY
11572
Tel: 1-800-293-9577
Site: www.wavehomesolutions.com
Nov2/2009
MP 100933
Rev. 2
Przeglądanie stron 0
1 2 3 4 5 6 ... 14 15

Podsumowanie treści

Strona 1 - WV-SCBT

READ CAREFULLY AND RETAIN FOR FUTURE REFERENCES INSTALLER’S MANUAL Sensor Control BT WV-SCBT Wave Home Solutions 2421 Long B

Strona 2

SET HUMIDITY CONTROL AND EXHAUST CONTROL: Refer to the “Operating Instructions” Manual included with the unit to change speed and dehumidistat setti

Strona 3 - INSTALLATION GUIDELINES

PLUG IN THE UNIT: Plug the unit into any 115V outlet. Note: A grounded extension cord with a maximum length of 10 feet may be

Strona 4

SECTION B Installation situations to be aware of: PROTRUDING WALL OR BASEBOARD: In this situation, block or insert spacer on the back of the unit

Strona 5

NOTE ABOUT CRAWL SPACE & BASEMENT COMBINATION: Depending on the square footage, the Sensor Control BT will be able to reduce the problems in the

Strona 6

FOR TECHNICAL ASSISTANCE Do not attempt to service the Sensor Control BT yourself. If you are not sure about certain functions, call our qualified

Strona 7

DO NOT INSTALL WV-SCBT NEXT TO REPLENISHMENT AIR SUPPLY. DO NOT DUCT INTO EXISTING EXHAUST DUCTS OR CHIMNEY. DO NOT PLACE WITHIN

Strona 8

DESCRIPTON OF UNITS MODEL NO. BASEMENT WV-SCBT 1800 sq. ft. SPECIFICATIONS Sensor Control B

Strona 9

INSTALLATION GUIDELINES SUMMARY OF KEY INSTALLATION FACTS – EXTREMELY IMPORTANT ! Unobstructed airflow and adequate replenishment air are essen

Strona 10

REPLENISHMENT AIR TO BASEMENT FROM UPSTAIRS OF HOME • The damp air exhausted by the Sensor Control BT must be replaced by the warmer/drier air from

Strona 11

• Make sure that no pipes, studs or wires are in the way. • Duct has to be dedicated and not combined with any other existing ductwork in operation

Strona 12 - SECTION B

FACTORS TO CONSIDER WHEN SELECTING UNIT LOCATION: The installation must be done in the basement or the lowest, wettest, coldest level of your dwellin

Strona 13

B.) Outside the building, find your pilot hole. Using a hole saw and the pilot hole as a guide,

Strona 14 - NOT TO DO

NOTE: If the unit has to be shorter than 86.5” cut the top of the bottom part. ATTACH FLEX, PIPE AND VENT TOGETHER:

Strona 15

FASTEN UNIT TO THE WALL: Leaving a 1 inch gap between the top of the unit and the ceiling (In case of a finished ceiling, leave a 1/

Komentarze do niniejszej Instrukcji

Brak uwag